Copyright©Zigong Tianyi Industry Co.,ltd. All Right Reserved 
蜀ICP备:16022254号-1  Supported by 300.cn

>
>
>
The design of HPGR carbide stud

SUPPORT

INFO

The design of HPGR carbide stud

Classification:
Support info
Author:
Source:
2020/07/02 11:02
Page view
Review:
[Abstract]:

The design of HPGR carbide stud

Based on years of experience and analysis of the damaged form of HPGR carbide stud, the influence of stress distribution rules, the effectiveness of crushing mechanism, etc, we analyze the structure of HPGR carbide stud. The preliminary discussion is as follows:

1.The structure of HPGR carbide stud:

Tian Yi

2.Analysis of structural use

(1)If material is high hardness and low viscosity, the surface of the HPGR will not be easy to form the material-wear-resisting layer. Under the continuous pressure of high pressure roller, carbide stud force is larger. So we should choice type B carbide stud to Improved service life.

(2)If material is low hardness and high viscosity, the surface of the HPGR will be easy to form the material-wear-resisting layer and the stress of carbide stud is small. So we should choice type A.

 

(3)If the diameter of HPGR and the daily processing capacity is large, and the load change is big and unstable, we should choice the type C to reduced production cost.

Key words:
Previous article:
Next article: